GE Keypad Controller 45631 Manual page 15

Keeping the controller awake:
In order to extend battery life, the controller normally goes into
stand-by mode (sleep) after approximately 10 seconds of inactivity
(no button Presses).
1.
It may be desirable to keep the controller awake so that
another controller can request Version or Manufacturer
Specific information.
a. Press & hold Add and Remove buttons for three seconds
to enter setup mode.
b. Then press and release the right side (up arrows) of the
Group/Scene buttons in sequence 1-2-3-4.
c. This starts a timer to keep the device awake for 30
seconds.
Interoperability with Z-Wave
Every Z-Wave certified product is designed to work with all
other Z-Wave certified products. A Z-Wave™ network can
integrate devices of various classes, and these devices can
be made by different manufacturers. Although this Keypad
Controller can use the Basic Command Class to provide
limited control of some non-lighting Z-wave devices, it is
intended for controlling Z-Wave devices using the lighting
control command classifications. The controller you select
should include the appropriate command classifications that
will provide full control of your devices. As an example, the
GE 45633 advanced remote with LCD provides support of the
command classes for Z-Wave certified door locks, thermostats
and lighting.
Devices
™