Toshiba TECRA M9 User Manual page 73

Removing a memory module (Slot A)
The slot A is reserved for main memory. Use the slot B for expanded
memory. If only one card is installed, use the slot A.
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the
Chapter 1, Getting Started if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
4. Follow steps 4 through 9 in
appear the memory module.
5. Push the latches to the outside to release the memory module. A spring
will force one end of the memory module up.
6. Grasp the sides of the module and pull it out.
■
If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
■
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
7. Rotate the keyboard back into place and secure the keyboard brace as
described in the previous section.
8. Install the battery pack. Refer to
Chapter 6, Power and Power-Up Modes, for details.
9. Turn your computer over.
User's Manual
section in Chapter 6, Power and Power-Up
Installing a memory module (Slot A)
Figure 3-11 Removing the memory module
Replacing the battery pack
Hardware, Utilities and Options
Turning off the power section in
to
Latches
section in
3-22