Table of Contents
Advertisement
Caution
To avoid damaging the
printer, never move the
paper set lever while the
Operate or Pause light
is flashing.
6. Push the paper set lever all the way in, then close the roll paper cover.
PRESS PAUSE BUTTON
7. Press the
button. The print head moves and the paper feeds into
Pause
printing position automatically.
display. (Even if you don't press
into printing position automatically after 10 seconds.)
Running a Nozzle Check
The nozzle check prints a pattern of dots that lets you see if any print head
nozzles are clogged. You can also use the nozzle check at this point to make
sure the printer is operating correctly before you connect it to your
computer.
There are two ways to run a nozzle check.
Using the printer's control panel buttons, as described below
•
Using the Nozzle Check utility from your printer software, as described
•
on page 6-1 (not available if you're accessing the printer over a network)
Follow these steps to print a nozzle check using the control panel buttons:
1. Make sure the printer is turned on but not printing, and paper is loaded.
1-9
Setting Up the Printer
appears briefly on the control panel display.
appears on the control panel
READY
, the paper and printer will move
Pause
|
1-9
Advertisement
Table of Contents
