Figure 6. Removal steps of fan assembly and heat sink assembly (continued)
Peel off the adhesive tape in the direction shown by arrow
assembly and the heat sink assembly.
c
When installing:
•
Before you attach the fan assembly to the computer, apply thermal grease,
at an amount of 0.2 grams, to the
too much or too less grease application can cause a thermal problem due
to imperfect contact with a component. You also need to peel the thin film
off from the rubber
additional thermal rubber
•
Use an adhesive tape to make sure that the fan assembly and the heat sink
assembly are attached firmly.
b
part shown in the figure above. Either
a
. In models with the discrete graphics chip, there is an
b
whose film to be peeled off.
c
Lenovo IdeaPad Y450
to detach the fan
4
a
4
59