Table of Contents
Advertisement
2.
If you have a hard disk, make sure you are logged onto the
directory that contains the DISKCOPY.COM file. If you don't
have a hard disk, make sure your working copy of the MS-DOS
Operating 1 diskette is in drive A.
3.
At the MS-DOS command prompt, type the following and press
Enter:
DISKCOPY A: A:
MS-DOS displays this message:
Insert SOURCE diskette in drive A:
Press any key when ready . . .
4.
If necessary, remove the Operating 1 diskette from drive A. Insert
the diskette you want to copy from (the source) in the diskette
drive and press any key. DISKCOPY starts to copy the contents
of the diskette to the computer's memory.
When the memory is full, the screen displays this message:
Insert TARGET diskette in drive A:
Press any key when ready . . .
5.
Remove the diskette from drive A and insert the blank diskette
(the target) in the drive. Press any key. DISKCOPY checks to see
if the new diskette is. formatted. If it is not, DISKCOPY formats
the diskette. The copy operation begins when the format is
complete.
6.
When DISKCOPY has copied the data from memory to the copy
diskette, the screen prompts you to insert the source diskette
again to copy the remaining data to the computer's memory.
Insert the original diskette in drive A and press any key.
7.
Once DISKCOPY has copied the rest of the original diskette's
data to the computer's memory, the screen prompts you to insert
the target diskette (the copy) again to copy the remaining data
from memory to the diskette. Insert the copy diskette and press
any key.
Using MS-DOS with Your
Equity 386
5-21
Advertisement
Table of Contents
