Epson 20 User Manual page 37

Epson equity 386/20 - user manual
Hide thumbs Also See for 20:
Table of Contents

Advertisement

When Auto speed is enabled, your computer automatically switches
to 8 MHz whenever it needs to access a diskette drive. It runs at
20 MHz for all other operations.
There are different types of copy-protected programs, and depending
on the type you have, you may or may not want to enable the Auto
speed function. Follow these guidelines:
If you are using a copy-protected program that can run only on a
l
diskette or that requires a key disk, try to start the program at
20 MHz. If this works, you do not need to enable the Auto speed
function. If you can't load the program at 20 MHz, enable Auto
speed.
If you are using a copy-protected program that does not require a
l
key disk, but requires a special procedure to install the program
on the hard disk, set the speed switch on the front panel to
8 MHz while you are installing the program. Once it is installed,
set the switch to 20 MHz, where you should be able to leave it
while you load and run the program. If this does not work, try
loading the program at 8 MHz and then switch to 20 MHz to use
it. Do not use Auto speed.
Follow these steps to change the Auto speed setting:
1.
Highlight
Auto speed
If the displayed setting is correct, press t to return to the main
menu.
2.
To change the setting, press
speedenabled.
3.
Highlight
** SAVE SETTINGS
the main menu.
Follow the same procedure if you later need to disable Auto speed.
and press
Enter.
The option changes to
Enter.
** and press
Running the Setup Program
You see this box:
Auto
to return to
Enter
2-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

386Equity 386/20

Table of Contents