GE 29897 User Manual page 14

2. Use NEXT or REVIEW to select the first digit.
3. Once the first digit is set, press ENTER. The unit beeps to confirm.
4. Repeat steps 2-3 until all the digits of the security code are set.
NOTE: To skip to the next setting, press MENU. To exit setup, press EXIT.
TIP: You can use the keypad to enter all the digits in one step. To enter 456, press 4,5, and 6.
Then press ENTER.
S D
ETTING THE
This adjustment allows you to select tone (touch-tone) or pulse (rotary) mode dialing. The
phone is automatically set for touch-tone use.
1. If you just adjusted the Remote Access menu, skip to step 2. If you haven't adjusted any other
setting, press and release the MENU button until DIALING is displayed.
2. Use NEXT or REVIEW or press the keypad number for the desired setting (1 for pulse, 2
for tone).
3. When finished, press ENTER to confirm. The unit beeps.
NOTE: To skip to the next setting, press MENU. To exit setup, press EXIT.
S R
ETTING THE
Depending on your area, you may need to set regional area codes. These are needed in
order for the phone to determine the number format to be displayed when a valid Caller ID
signal is received. Calls received that match any of the regional area codes are displayed as
10 digits. If the number is not displayed correctly, the phone may not be able to dial back the
number properly. You can store up to 6 regional area codes.
You may need to use this feature if you have:
• Multiple area codes
• Overlapping area codes
• Areas that require 10-digit dialing.
1. If you just adjusted the Dialing menu, skip to step 2. If you haven't adjusted any other
setting, press and release the MENU button until REGIONAL AC# is displayed. The first
digit of code #1 flashes.
14
M
IALING ODE
A
EGIONAL REA
C
ODES