About Indicator Status; If An Indicator Turns On - Panasonic PT-EZ570UL Operating Instructions Manual

About indicator status

If an indicator turns on

If a problem occurs within the projector, it will be notified with the temperature indicator <TEMP>, the filter
indicator <FILTER>, the shutter indicator <SHUTTER>*, and the lamp indicator <LAMP>.
Check the status of the indicators and take the following action.
* (Only for EZ570 series, EW630 series and EX600 series.)
CAUTION
Before you take a remedial measure, follow the procedure of switching the power off indicated in "Turning off the projector".
z
( Æ page 40)
If multiple indicators light or blink, verify the status of the projector by looking at each indicator.
z
Note
Confirm the status of the power indicated on the <ON(G)/STANDBY(R)> indicator.
z
When operating correctly
J
The status of the indicator is displayed with the following symbols.
Off On Flashing
 
: ,  : , :
<ON(G)/
<TEMP>
STANDBY(R)>
Green/Red/
Orange
//
//
//
*
2

//
* 2

//
*
2

//
//
//
/
* 2

 /
*1: The indicator will change according to different conditions, regardless of the status of other indicators.
*2: The indicator will flash in approximately 1-second intervals.
90
- ENGLISH
Off or On or Flashing
, „ :
Indicators
<SHUTTER/
<FILTER>
AV MUTE>
Red Orange
Blue
  
1 1 1
„* „* „*
1 1 1
„* „* „*
1 1 1
„* „* „*
1 1 1
„* „* „*
1 1 1
„* „* „*
1 1

„* „*

1 1 * 2
„* „*
1 1  * 2
„* „*
Status of the projector
<LAMP>
Orange
The power plug has been removed from the

outlet.
The projector is in the standby mode.
Turns on when pressing the <POWER ON>
1
„*
button on the remote control or the <
button on the side control.
1 The projector is operating normally.
„*
The lamp is cooling down. The projector does
not turn on when pressing the <POWER ON>
1
„*
button on the remote control or the <
on the side control until the standby indicator
<ON(G)/STANDBY(R)> changes to red.
The projector is in the power management
1 mode. The lamp will turn on when controlling the
„*
projector, allowing the user to start operating it.
Power management mode is [On] and the lamp
1
„*
is cooling down.
The shutter function has been turned on.
1 Press any button on the remote control or the
„*
side control to cancel the function.
The projector is in the shutter management
1 mode. The lamp will turn on when controlling the
„*
projector, allowing the user to start operating it.
Shutter management mode is [On] and the lamp
1
„*
is cooling down.
>
> button