Table of Contents
Advertisement
Controlling the Projector via Scheduling
Date/Time Settings
The Date/Time setting can be adjusted via a web browser.
Example: If the IP address of the projector is set to 192.168.1.10:
) Enter [https://192.168.1.10] into the address bar of the web browser.
Enter the Administrator ID and Password and click [Logon].
) Click [Date/Time Settings] on the main menu and configure each item.
Refer to the [Date/Time Settings] item in [Configuring and Controlling the
Projector via a Web Browser] for further information.
3) Click the [Apply] button to save the settings.
NOTE
• A Network Restart is required after the Daylight Savings Time or
SNTP configuration settings have been changed.
• The battery for the built in clock may be dead if the clock loses time even
when the DATE and TIME have been set correctly. Replace the battery by
following the instructions on replacing the battery.
(User's Manual - Operating Guide : Replacing Internal Clock battery)
• The Internal Clock's time may not remain accurate. Using SNTP is
recommended to maintain accurate time.
30
(18)
Advertisement
Table of Contents
