Sears Craftsman 113.198311 Operator's Manual page 18

7. Place the front table on the saw so that the
mounting screws line up with the U-clips. The
front table should extend about one inch
beyond the trim caps.
8. Start the mounting screws into the U-clips
using a Phillips screwdriver. Tighten the
screws until the heads are just touching the
table. Make sure that the table is not
squeezing the rubber grommets. Otherwise,
leveling the table later on will be difficult.
9. Start the leveling screws into the leveling
holes using a 1/8 inch Hex-L wrench. Tighten
the screws until they are flush with the table.
10. Attach the left rod to the left table rail
with a hex head bolt and flat washer. Then
put another washer and a locknut on the bolt,
and tighten using two 1/2 inch wrenches or
sockets. (Figure 41)_
Left Table Rail
\
\
Fig. 41
11. Repeat step 10 with the right table rail.
18