Troubleshooting Guide - Craftsman 919.670070 Owner's Manual

PROBLEM CA USE
Engine wifl not start
No electHcM output
Repeated circuit breaker
tripping
Generator overheating the
circuit breaker depressed
1. Low on fuei or oil
2. Ignition switch in "Off" position.
3. Fauityspark piug,
4. Choke in wrong position.
5. Fuei shut-off vaive in dosed
position.
6. Unit ioaded during start-up.
7. Spark piug wire ioose,
1. Fauity receptacb.
2. Circuit breaker kicked out.
3. Defective capacitor.
4, Faulty power cord.
5, GFCI receptacle circuit breaker
kicked out,
1, Overload
2, Faulty cords or equipment.
1, Generator overloaded,
2, Insufficient ventilation,
1, Add fuel or oii,
2, Turn to "ON" position
3, Replace spark plug,
4, Adjust choke accordingly,
5, Open fuel shut-off valve,
6, Remove load from unit,
7, Attach wire to spark plug,
1. Have Authorized Sears Service
Center replace.
2. Depress and reseL
3. Have Authorized Sears Service
Center replace capacitor.
4. Repair or replace cord.
Depress and reseL
5.
.
2,
Reduce load.
Check for damaged, bare, or
frayed wires on equipment.
Replace.
1, Reduce load,
2, Move to adequate supply of
fresh air,
21 -- ENG NGP670070