ASSEMBLY
INSTALL
MULCHER
PLATE
(See Figs. 5 and 6)
•
Install two latch hooks to mulcher plate using screw,
washe=r,TocEw-a-s_erl ahd _efd nut _._ _h_wn.
NOTE _.Pre-assemble
weld nut to latch hook by inserting
weld nut from the top with hook pointing down.
•
Tighten hardware securely.
•
Raise and hold deflector shield in upright position.
•
Place front of mul_:her plate over front of mower deck
opening and slide into place, as shown.
•
Hook front latch into hole on front of mower deck.
.
Hook rear latch into hole on back of mower deck.
CAUTION:
Do not remove discharge
guard from mower.
Raise and
hold
guard when attaching
mulcher
plate
and allow it to rest on plato while in
operation.
&
TO CONVERT
TO BAGGING
OR
DISCHARGING
Simply remove mulcher plate and store n a safe place.
Your mower is now ready for discharging or installation of
optional grass catcher accessory.
HOOK POINTS
\\DOWN
WELD NUT
FROM THE TOP
"_
LATCH
HOOK
LOCK
WELD.
WASHER
NUT
_
N.
SCREW
LATCH
HOOK
LOCK
WELD
WASHER
NUT
FIG. 5
WASHER
MULCHER
_LATE
DEFLECTOR
SHIELD
HOOKS
FIG. 6
•/ CHECKLIST
BEFORE
YOU OPERATE
AND ENJOY YOUR
NEW
TRACTOR, WE WISH TO ASSU RE -I-HAT YOU RECEIVE
THE BEST PERFORMANCEAND
SATISFACT!ON
FROM
THIS QUALITY PRODUCT.
PLEASE REVIEW THE FOLLOWING
CHECKLIST:
,/
All assembly instructions have been completed.
,/
No remaining loose parts in carton.
/
Battery is properly prepared and charged.
(Minimum
1 hour at 6 amos).
,/
Seat is adjustea comfortably and tightened securely.
,/
All tires are properly inflated
(For shipping purposes,
the tires were overintlated at the factory).
,/
Be sure mower deck is properly leveled side-to-side/
front-to-rear for aest cutting results.
(Tires must be
properly inflated for leveling).
€"
Check mower and drive belts. Be sure they are routed
properly around pulleys and inside all be!t keepers.
,/
Check wiring. See that all connections are still secure
and wires are propeny clamped.
WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY
EXTRA ATTENTION TO THE FOLLOWING IMPORTANT
ITEMS:
€"
Engine oil is at 3roper level.
,/
Fuel tank is filled with fresh, clean, regular unleaded
gasoline.
,/
Become familiar with all controls - their location ane
function. Ouerate them before you start the engne.
¢"
Be sure brake system is in safe operating cond'tion.
9