Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
TO REPLACE
HEADLIGHT
BULB
ENGINE
•
Raise hood.
TO 'ADJUST
THROTTLE
CONTROL
CABLE
•
Pull bulb holder out of the hole in the backside of the............
(SeeFig•
29)
...........................................
grill.
The throttle control has been preset at the factory and
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
•
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring. See electrical wiring diagram in Repair
Parts section of this manual.
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-in fuse.
The
fuse holder is located behind the dash.
TO REMOVE
HOOD AND GRILL (See Fig. 28)
•
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor.
Grasp hood at sides, tilt
forward and lift off of tractor.
•
To reinstall, slide hood pivot brackets into slots in
frame.
•
Reconnect headlight wire connector and close hood.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 28
adjustment should not be necessary.
Check adjustment as
described below before loosening cable.
If adjustment is
necessary, proceed as follows:
•
With engine not running, move throttle control lever to
fast (,_) position.
°
Check that swivel is against side of quarter circle. If it
is not, loosen cable clamp screw and pull cable back
until swivel is against quarter circle.
Tighten cable
clamp screw securely.
TO ADJUST
CHOKE CONTROL
(See Fig. 30)
The choke control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable.
If adjustment is
necessary, proceed as follows:
•
With engine not running, move choke control (!ocated
on dash panel) to full choke (IXI) position.
=
Remove air cleaner cover, filter and cartridge plate to
expose carburetor choke (see "AIR FILTER" in the
Customer Responsibilities
section of this manual).
°
Choke should be closed. If it is not, loosen casing
clamp screw and move choke cable until choke is
completely closed. Tighten casing clamp screw se-
curely.
•
Reassemble air cleaner.
CLAMP_
QUARTER
CIRCLE
SWIVEL
FIG. 29
CHOKECLOSED
CASING
CLAMP J
SCREW
FIG. 30
CHOKE
LEVER
1
23
Advertisement
Table of Contents
