Table of Contents
Advertisement
Pull the saw blade through
the
workpiece
to the distance
shown below.
Fig. 146- Distance
Needed to Complete
Crosscut
12. Support
and hold the workpiece
down
and against
the fence firmly with your left
hand.
13. Pull blade through
fence and workpiece
just enough
to complete
the cut. Fig. 146.
14. Return saw to its rearmost position and
continue to hold the saw handle.
15. Turn saw off.
16. Wait for the blade to stop turning.
17. Remove
yellow key form red switch.
10. Insert yellow key into red switch.
11. Turn saw on.
WARNING:
Saw blade can be
pulled
into or over fingers
or
hand. Fingers
or hand can be cut off.
Keep hand holding
the workpiece
at
least 8 inches to the left of, and out of
the path of the saw blade. Keep hand in
view at all times.
Repetitive
Crosscuts
To make repetitive
crosscuts:
1. Use _vo pieces
of 1 inch by 2 by 2 inch
lumber.
2. Use a C clamp to clamp
one piece on each
side of the lower right edge of the radial arm.
3. Clamp pieces of lumber at the distance
necessary to complete the crosscut.
Fig. !4 7 - Hand Placement for Crosscuts
Fig. 148
64
Advertisement
Table of Contents
