Out-Rip Reference - Sears Craftsman 113.197410 Operator's Manual

go to the next section, or
If the display says:
I sn° !
.,p
!_!.L!
push the ]_F SET button again, Then go to
the next section.
Out-rip Reference
The "0" reference point for out-rip is usually
set with the blade ten inches from the fence.
1. Unlock the swivel lock.
2. Turn the motor to the out-rip position with
the motor between the blade and the fence.
3. Lock the swivel lock.
4. Unlock the table locks and move the fence
behind the spacer and rear table. (Figure 146)
5. Lock the table locks.
6. Unlock the rip lock.
7. Move the motor until the blade is 10 inches
in front of the fence. Use a framing square,
ruler or tape measure to measure this distance.
(Figure 132)
8. Lock the @ lock.
9. Push the RIP button.
10. If the display shows the O-RIP function,
go to step 11, or
If the display shows the RIP function, push
the RIP button again. Then go to step 11.
11. Push the REF SET button.
12. If the display says:
l '-"-'!
o-.,P .U U
13. Push the REF SET button again.
The display will say:
!
O-RIP
Fence
Blade
Fig. 132 - OukR_ Re_rence
55