Craftsman 917.4790A Owner's Manual page 8

21" multi-cut rotary lawn mower
Hide thumbs Also See for 917.4790A:
Table of Contents

Advertisement

Available languages

Available languages

The operation of any lawn
SAFETVG'ASSES
mower can result in foreign
objectsthrowninto the eyes,
which can result in severe
eye damage. Always wear
safety glasses or eye shields while oper-
ating your lawn mower or performing any
adjustments or repairs. We recommend a
standardsafetyglassesorwide visionsafety
mask worn over spectacles.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
Engine speed was set at the factory for
optimum performance.
It is not adjustable.
ENGINE ZONE CONTROL
_I, CAUTION:
Federal regulations
require
an engine control to be installed on this
lawn mower in order to minimize the
risk of blade contact injury. Do not under
any circumstances
attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
o Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST CUTTING
HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements.
Medium position is
best for most lawns.
o
To change cutting height, squeeze ad-
juster lever toward wheel. Move wheel
up or down to suit your requirements.
Be
sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned when
plate tab inserts into hole in lever. Also, 9-
position adjusters (if so equipped) allow lever
to be positioned between the plate tabs.
LEVER BACKWARD
TO LOWER MOWER
Plate tab
o To convert to mulching or discharging
operation,
remove grass catcher and
close rear door.
Pivot pins
Rear
Grass
catcher
handle
Catcher frame hook
SIDE DISCHARGING
o Rear door must be closed.
o Open mulcher door and install dis-
charge deflector
under door as shown.
o Mower is now ready for discharging
operation.
o To convert to mulching or bagging opera-
tion, discharge deflector must be removed
and mulcher door must be closed.
SIMPLE STEPS TO REMEMBER
WHEN
CONVERTING
YOUR LAWN MOWER
FOR MULCHING
-
1. Rear door closed.
2. Mulcher door closed.
FOR REAR BAGGING -
1. Grass catcher installed.
2. Mulcher door closed.
FOR SIDE DISCHARGING
-
1. Rear door closed.
_
Discharge deflector installed.
CAUTION:
Do not run your lawn mower
without rear door closed, clipping deflector
or approved grass catcher in place.
Never
attempt to operate the lawn mower with the
rear door removed or propped open.
LEVER FORWARD TO RAISE MOWER
Lever
TO CONVERT
MOWER
Your lawn mower was shipped ready to be
used as a mulcher.
To convert to bagging
or discharging:
REAR BAGGING
o Lift rear door of the lawn mower and
place the grass catcher frame hooks
onto the door pivot pins.
Open mulcher door
Install
discharge
8 deflector

Advertisement

Table of Contents
loading

Table of Contents