Advertisement
CONTAINER
MOUNTING
(See
Fig. 6)
No hardware
required
1.
Install one container to left side first with warning to
outside of unit. Install other container to right side.
NOTE: Right container should always overlap left container
at center support.
2.
Close cover and lock latch handle over center support
tube.
COVER LATCH
HANDLE
CONTAINER
WARNING
CONT_NER
HANDLE
CENTER
SUPPORT
TUBE
CONT_NER
WARNING
FIG. 6
LOWER CHUTE (See Figs. 7A & 7B)
Use Hardware - - GROUP "D"
1.
Press weld nut into rubber latch and install two latch
hook assembliesto lowerchute usingscrew,flatwasher,
and lock washer as shown.
2.
Tighten hardware securely.
3.
Raise and hold deflector shield in upright position.
4.
Place front of chute over front of mower deck opening
and slide into place as shown.
5.
Hook front latch down into latch hole at front of mower
deck.
6.
Hook rear latch down into latch hole at back of mower
deck.
I
_[)
CAUTION: Do not remove discharge [
guard from mower. Raise and hold guard
when attaching lower chute and allow it
to rest on chute while in operation.
WASHER
LOCK
WASHER
LATCH
DEFLECTOR
SHIELD
LATCH
WELD NUT
/E
LOCK
WASHER
WASHER
FIG. 7A
SCREW
WELD NUT
FIG. 7B
LATCH
HOOKS
9
Advertisement
