Product Specifications; Tires Care; Blade Care; To Replace Blade - Craftsman 917.377292 Owner's Manual

6.5 horsepower 22" rear discharge power propelled rotary lawn mower
Table of Contents

Advertisement

Available languages

Available languages

PRODUCT SPECIFRCATIONS
MODEL NUMBER
917.377292
SERIAL
NUMBER
DATE OF PURCHASE
HORSEPOWER:
6,5
DISPLACEMENT:
12.56 CU, IN.
GASOLINE
CAPACITY/TYPE:
1_5QUARTS
UNLEADED
REGULAR
OIL TYPE (APt-SF/SG/SH:
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW 32°F)
OIL CAPACITY:
27 OZS.
SPARK PLUG(GAP:
.030")
CHAMPION
RJ19LM
VALVECLEARANCE:
INTAKE:
°004" - °008"
EXHAUST:
.004" - .008"
SOLID STATE IGNITION
AIR GAP:
.0125 IN,
BLADE BOLT TORQUE:
35-40 FT. LBS.
• The model and serial numbers wilt be found on a decal attached to the rear of the
lawn mower housing.Record
both serial number and date of purchase in space
provided above.
LAWN MOWER
Always observe safety rules when performing
any maintenance.
TIRES
o Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber°
o Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
tire damage.
BLADE
CARE
For best results, mower blade must be kept
sharp. Replace bent or damaged blades.
TO REMOVE BLADE
o Disconnect spark plug wire from spark plug
and place wire where it cannot come in
contact with spark plugo
• Turn lawn mower on its side. Make sure air
filter and carburetor are up,
o Use a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt,
• Protect your hands with gloves and/or wrap
blade with heaW cloth.
o Remove blade bolt by tuming counter-
clockwise, Use a 9/16" box or open-end
wrench°
° Remove blade and attaching hardware
(bolt, lock washer and hardened washer).
NOTE:
Remove the blade adapter and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly, Replace adapter if damaged,
Blade
Crank shaft
washer
Trailing adaptor
edge
TO REPLACE BLADE
o Position the blade adapter on the engine
crankshaft. Be sure key in adapter and
keyway in crankshaft are aligned.
• Position blade on the blade adapter aligning
the two (2) holes in the blade with the raised
lugs on the adapter.
!1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ez3 917.377292

Table of Contents