Table of Contents
Advertisement
ASSEMBLY
Read these instructions
and this manual in its entirety
before you attempt to assemble or operate your new lawn
mower. Your new lawn mower has been assembled at the
factory with the exception of those parts left unassembled
for shipping purposes.
To ensure safe and proper opera-
tion of your lawn mower', all parts and hardware you
assemble must be tightened
securely
Use the correct
tools as necessary to ensure proper tightness
All parts
such as nuts, washers, bolts, etc. necessary to complete
the assembly have been placed in the parts bag.
TO REMOVE
LAWN MOWER FROM
CARTON
Remove loose parts included with mower.
Cut down two end corners of carton and lay end panel
down flat
•
Remove all packing materials
except
padding be-
tween upper and lower handle and padding holding
operator presence control bar to upper handle.
•
Roll lawn mower out of carton and check carton
thoroughly for additional
loose parts.
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD
HANDLE
(See Figs. 1 & 2)
IMPORTANT:
UNFOLD HANDLE CAREFULLY SO AS
NOT TO PINCH OR DAMAGE CONTROL CABLES_
•
Raise lower handle section to operating position and
align hole in handle with or're of three height positioning
holes.
o
Insert handle bolt through handle and bracket and
secure with knob
Repeat for opposite side of handle.
Raise upper handle section to operating position, re-
move protective padding and tighten handle knobs
securely.
°
Remove any packing material from around control bar.
.
Your handles may be adjusted for' your' mowing com=
fort
Refer to Service and Adjustments section of this
manual.
OPERATOR
PRESENCE
CONTROLBAR
UPPER HANDLE
LIFT UP
LOWER HANDLE
FIG. 1
HANDLE
ADJUSTMENT
BRACKET
MOWING
POSITION
KNOB
FIG. 2
6
Advertisement
Table of Contents
