Table of Contents
Advertisement
Available languages
Available languages
Read these instructions and this manual
in its entirety before you attempt
to
assemble
or operate your new lawn
mower.
IMPORTANT:
This lawn mower is
shipped
WITHOUT
OIL OR GASOLINE
in
the engine.
Your new lawn mower has been as-
sembled
at the factory with the exception
of those parts left unassembled
for
shipping
purposes.
All parts such as nuts,
washers,
bolts, etc., necessary
to com-
plete the assembly
have been placed in
the parts bag. To ensure safe and proper
operation
of your lawn mower, all parts
and hardware
you assemble
must be
tightened
securely.
Use the correct
tools
as necessary
to ensure proper tightness.
TO REMOVE LAWN MOWER FROM
CARTON
1. Remove
loose parts included with
mower.
2. Cut down two end corners
of carton
and lay end panel down flat.
3. Remove
all packing materials except
padding between
upper and lower
handle and padding holding operator
presence
control bar to upper handle.
4.
Roll lawn mower out of carton and
check carton thorougly
for additional
loose parts.
HOWTO
SET UP YOUR
LAWN
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle carefully so
as not to pinch or damage control cables.
1. Raise lower handle section to
operating position
and squeeze
the
bottom ends of lower handle towards
each other until the pin in handle can
be inserted into one of the three
height adjustment
holes.
2.
Remove
protective padding, raise
upper handle section into place on
lower handle and tighten both handle
knobs.
3.
Remove any packing
material from
around control bar.
Your handles may be adjusted for your
mowing comfort.
Refer to "ADJUST
HANDLE"
in the Service and Adjustments
section of this manual.
control bar
Upper
LIFT
UP
Mowing
position
Lower handle
Handle pin
SQI
Handle
J
bracket
TO INSTALL
ATTACHMENTS
Your lawn mower was shipped ready to
be used as a rnulcher. To convert to
bagging
or discharging,
see "TO CON-
VERT MOWER"
in the Operation section
of this manual.
5
Hide quick links:
Advertisement
Table of Contents
