Traction Drive Cable Adjustment - Craftsman C950524312A Owner's Manual

ADJUSTMENT/REPAIR
Traction Drive Cable Adjustment
_lb ARNING: Drain the gasoline outdoors, away
from fire or flame.
1. Remove the gas from the gas tank. Stand the snow
thrower up on the front end of the auger housing.
2. Loosen the bolts on each side of the bottom panel (see
Figure 41).
3. Remove the bottom panel.
4. Disconnect the "Z" fitting from the drive lever (see
Figure 39),
5. Slide the cable boot off the cable adjustment bracket
(see Figure 42).
6. Push the bottom of the traction drive cable throughthe
cable adjustment bracket untilthe "Z" hook can be re-
moved.
7. Remove the "Z" hook from the cable adjustment
bracket. Move the "Z '° hook down to the next adjust-
ment hole.
8. Pull the traction drive cable up through the cable ad-
justment bracket.
9, Put the cable boot over the cable adjustment bracket.
10, Install the "Z" hook to the traction drive lever (see
Figure 39).
11. To check the adjustment, depress the drive lever and
check the length of the drive spring (see Figure 43). In
correct adjustment, the length of the drive spring is
minimum 3 inches (76 mm.)
maximum 3-3/8 inches (85 mm.),
12. Install the bottom panel (see Figure 41).
13. "nghtenthe bolts on each side of the bottom panel.
31