To Level Mower Housing - Craftsman 917.273622 Owner's Manual

2. Slide mower under tractor with deflec-
tor shield to right side of tractor.
mMPORTANT: Check belt for proper rout-
ing in all mower pulley grooves.
3. If equipped, turn height adjustment
knob counterclockwise until it stops.
4. Lower mower linkage with attachment
lift control.
5. Be sure belt tension rod is in disen-
gaged position.
6. Install belt into electric clutch pulley
groove.
7. Place the suspension arms on outward
pointing deck pins. Retain with double
loop retainer spring with loops up as
shown.
8. Install front plate assembly to tractor
suspension brackets and retain with
single loop retainer springs as shown.
9. Position front plate assembly between
front mower brackets. Raise deck and
plate assembly to align holes and insert
flanged pins. Secure pins with double
loop retainer springs between the plate
assembly and mower brackets.
NOTE: To assist in locating hole in flanged
pin, the hole in pin is inline with notch on
head of pin. If necessary, move mower
side-to-side to give space between plate
and mower brackets.
mMPORTANT: Check belt for proper rout-
ing in all mower pulley grooves.
10.Engage belt tension rod by pushing rod
into locking bracket.
_CAUTmON: Belt tension rod is spring
loaded. Have a tight grip on rod and en-
gage slowly.
11. Connect anti-sway bar to chassis
bracket under left footrest and retain
with double loop retainer spring.
12. If equipped, turn height adjustment
knob clockwise to remove slack from
mower suspension.
13. Raise deck to highest position.
TO LEVEL MOWER HOUSmNG
Adjust the mower while tractor is parked
on level ground such as a carport or ga-
rage. Make sure tires are properly inflated
(See "PRODUCT SPECIFICATIONS"
section of this manual). If tires are over or
underinfiated, you will not properly adjust
your mower.
SIDE-TO-SIDE ADJUSTMENT WITH
BUBBLE LEVEL
NOTE: If necessary, check side-to-side
surface below tractor for levelness with a
long board and the bubble level.
,, Using the lift lever, place mower in
position where no part of the mower,
including gauge wheels, is touching the
ground.
,, From left side of tractor, find the level
decal on top of mower and place bubble
level on decal as indicated.
,, Mower is level side-to-side when bubble
is between the two lines in the bubble
level.
* If adjustment is necessary, under left
hand footrest, turn lift link adjustment
nut (above yellow cap) in appropriate
direction to bring bubble between the
lines in the bubble level.
,, Remove bubble level from mower and
store in a safe place.
Bubble Level
Brake
Pedal
Level Decal
ALTERNATE SIDE-TO-SIDE
ADJUSTMENT METHOD
', Raise mower to its highest position.
,, Measure height from bottom edge of
mower to ground level at front corners
of mower. Distance "A" on both sides of
mower should be the same.
,, If adjustment is necessary, make adjust-
ment on one side of mower only.
,, To raise one side of mower, tighten lift
link adjustment nut on that side.
,, To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each full turn of adjustment nut
will change mower height about 3/16".
* Recheck measurements after adjusting.
Bottom Edge of Bottom Edge of
Mower to Ground Mower to Ground
20