Ptt (Roger Tone); Automatic Power Save Feature; Auto Power Off; Room Monitor Feature - Motorola TLKR T8 Owner's Manual

set the Key tone to OFF.
2. Press OK to confirm the setting.

PTT (Roger tone)

Roger Beep is a BEEP that is sent to notify the end of
transmission (PTT and VOX transmission). Roger can be
heard through the speaker when Key Beep is On. It is
transmitted even if Key beep is turned Off. However, Roger
Beep will not be heard from the speaker.
To turn the PTT beep ON:
1. Enter the MENU/GRP. Advance through the Menu until
the "PTT" display. Press OK then press the
to set the PTT Beep tone to ON mode.
2. Press OK to confirm the setting.
To turn the PTT beep OFF:
1. Enter the MENU/GRP. Advance through the Menu until
"PTT" display. Press OK then press the
set the PTT tone to OFF.
2. Press OK to confirm the setting.

Automatic Power Save Feature

Your radio has a unique circuit designed to dramatically
extended the life of the batteries. If there is no transmission
or an incoming call within 3 seconds, your radio switches to
the Power Save Mode. The radio is still able to receive
transmissions in this mode.

Auto Power Off

Auto Power Off feature allows you to set the time that the
radio turns off automatically.
1. Enter the MENU/GRP. Advance through the Menu until
12
the"PWR"display. Press OK then press the
to select the Auto power off mode. Selection mode can
be set to On, 1hr, 2hr or 3 hr.
2. Press OK to confirm the setting.

Room Monitor Feature

You can use one of your TLKR T8 radios as a room monitor
and use the other radio to listen to and keep a check on the
voice in another room. When you set the room monitor
feature, the monitoring radio will detect voice/noises
(according to the sensitivity level you set) and transmit back
to the listening radio without pushing the PTT key. The
monitoring radio is not able to receive any transmissions in
or key
this mode.
To turn the Room Monitor ON:
1. Enter the MENU/GRP. Advance through the Menu until
the "ROOM" display. Press OK then press the
key to select the Room monitor to Off or level L1, L2, L3,
or key to
L4, L5.
2. Channel monitoring will start immediately.
To set the Room Monitor OFF:
1. Enter the MENU/GRP. Advance through the Menu until
the "ROOM" display. Press OK then press the
key to set the Room monitor to Off.
2. Press OK to confirm the setting.
Note:
- Pressing the PTT key in Room Monitor mode is invalid and
the radio emits PTT Error tone.
- When the voice/noise in another room continues more
than 60 seconds, the monitoring radio stops monitoring for
5 seconds, and then resumes.
or key
or
or