To connect cables from the RAID card to the backplane, do one of the following depending on the type of
your RAID card:
• If you are using a ThinkServer RAID 700 Adapter, do the following:
1. Use one mini-SAS to mini-SAS signal cable. Connect the mini-SAS connector
the RAID card. Then, connect the mini-SAS connector
2. If your server has more than four hard disk drives installed, use the other mini-SAS to mini-SAS signal
cable. Connect the mini-SAS connector
mini-SAS connector
• If you are using a ThinkServer RAID 500 Adapter, do the following:
1. Use the mini-SAS to mini-SAS signal cable. Connect the mini-SAS connector
RAID card. Then, connect the mini-SAS connector
2. If your server has more than four hard disk drives installed, use the other mini-SAS to mini-SAS
signal cable. Connect the mini-SAS connector
mini-SAS connector
Refer to the following topics for information about the connector locations and the power cable connections:
•
"Hot-swap hard disk drive backplane" on page 28
•
"RAID card" on page 26
•
"System board components" on page 32
System board components
The following illustration shows the component locations on the system board.
32
ThinkServer RD530 Hardware Maintenance Manual
1
to the ports 7-4 on the RAID card. Then, connect the
2
to the mini-SAS ports 4-7 on the backplane.
4
to the mini-SAS ports 4-7 on the backplane.
4
to the mini-SAS ports 0-3 on the backplane.
2
to the mini-SAS ports 0-3 on the backplane.
3
to the port 1 on the RAID card. Then, connect the
3
to the ports 3-0 on
1
to the port 0 on the