Ordering Replacement Parts - Napoleon GOURMET GRILLS Manual

Problem
Flames lift away from
burner, accompanied by
the smell of gas, and pos-
sibly difficulties in lighting.
Burner will not light with the
igniter, but will light with a
match.
Humming regulator.
Burners will not crosslight
each other.
"Paint" appears to be peel-
ing inside lid or hood.

ORDERING REPLACEMENT PARTS

Possible Causes
Improper air shutter adjust-
ment.
Loose electrode or switch
terminal wires.
Improper gap at electrode tip.
Lifting flames on burner.
Dead battery.
Normal occurance on hot
days.
Plugged ports along back of
burner.
Grease build up on inside
surfaces.
Solution
Close air shutter slightly according to combustion air
adjustment instructions.
Check that electrode wires are firmly pushed onto the
terminal on ignition module. Check that the lead wires
from the module to the ignition switch are firmly
pushed onto their respective terminals.
Ensure that the collector box is tight, and the gap
between the electrode end and the collector box is
between 1/8 - 3/16". The gap can be adjusted by
bending the box in or out.
Close air shutter slightly - see previous problem.
Replace the battery with a new one.
This is not a defect. It is caused by internal vibrations
in the regulator, and does not affect the performance
or safety of the gas grill.
Clean burner ports. See burner maintenance
instructions.
This is not a defect. The finish on the lid and hood is
porcelain, and will not peel. The peeling is caused by
hardened grease, which dries into paint-like shards,
that will flake off. Regular cleaning will prevent this.
See cleaning instructions.