Status Read Command; Format; Transfer Example; Operation Requirements - Sanyo PLC-XK2200 - 2200 Lumens Manual

PLC-XK2200 / 2600 / XK3010 Basic Serial Command Specifications

7. Status Read Command

7.1. Format

7.1.1. PC issues commands in format as below;
"CR" Command [CR]
Commandÿ 1 character(See Basic Status Read Command Table)
7.1.2. When a projector receives the appropriate command, it returns a character line as the
required data.
Required Data [CR]
Required Dataÿ A character line(See Basic Status Read Command Table)
7.1.3. When the received data cannot be decoded, the projector returns "?" [CR].

7.2. Transfer Example

Get input mode for projector with basic commands
PC → Projector
Projector → PC

7.3. Operation Requirements

When Eco mode is selected in Standby mode of Setting menu and projector is in Standby, Status
Read Commands are invalid.
7.4. Status Read Command
Command "CR0" [CR]
Detail Get the projector's operating status
Acceptable
Response
Unacceptable
Command(issues a command of getting current input mode)
"C" "R" "1" "CR"
"%1" [CR]
"00" = Power ON
"80" = Standby
"40" = Countdown in process
"20" = Cooling Down in process
"10" = Power Failure
"28" = Cooling Down in process due to Temperature Anomaly
%1
"88" = Coming back after Temperature Anomaly
"24" = Power Save/Cooling Down in process
"04" = Power Save
"21" = Cooling Down is in process after Power off due to lamp
failure
"81" = Standby after Cooling Down due to lamp failure
"?" [CR]
19/23
"1"
Processing Response
(A few msÿ ^ 1s)
(
Shows Computer 1 is selected)
"CR"