Understanding the printer menus
Use
Enhance Fine Lines
On
Off
Gray Correction
Auto
Off
Brightness
‑6 to 6
Contrast
0–5
Utilities menu
Use
Format Flash
Yes
No
Hex Trace
Coverage Estimator
Off
On
To
Enable a print mode preferable for files such as architectural drawings, maps, electrical
circuit diagrams, and flow charts.
Notes:
•
Off is the factory default setting.
•
You can set this option from the printer software. For Windows users, click File >
Print, and then click Properties, Preferences, Options, or Setup. For Macintosh
users, choose File > Print, and then adjust the settings from the Print dialog and
pop‑up menus.
•
To set this option using the Embedded Web Server, type the network printer IP
address in the Web browser address field.
Automatically adjust the contrast enhancement applied to images.
Note: Auto is the factory default setting.
Adjust the printed output either by lightening or darkening it. You can conserve toner
by lightening the output.
Note: 0 is the factory default setting.
Adjust the contrast of printed objects.
Note: 0 is the factory default setting.
To
Format the flash memory.
Warning—Potential Damage: Do not turn off the printer while the flash memory is
being formatted.
Notes:
•
Flash memory refers to the memory added by installing a flash memory card in
the printer.
•
Yes deletes all data stored in the flash memory.
•
No cancels the format request.
•
The flash memory option card must not be read/write‑ or write‑protected.
•
This menu item appears only when a non‑defective flash memory card is
installed.
Assist in isolating the source of a print job problem.
Notes:
•
When activated, all data sent to the printer is printed in hexadecimal and
character representation, and control codes are not executed.
•
To exit or deactivate Hex Trace, turn off or reset the printer.
Provide an estimate of the percentage coverage of toner on a page. The estimate is
printed on a separate page at the end of each print job.
Note: Off is the factory default setting.
78