Installing An Sfp Transceiver; Figure 3-5. Installing An Sfp Transceiver - Enterasys V2H124-24P Hardware Installation Manual

2. Set the device on a flat surface near an AC power source, making sure there
are at least two inches of space on all sides for proper air flow.
3. If installing a single switch only, go to "Connecting to a Power Source" at the
end of this chapter.
4. If installing multiple switches, attach four adhesive feet to each one. Place each
device squarely on top of the one below, in any order.

Installing an SFP Transceiver

1
2 2
2 3
To install an SFP transceiver, perform the following steps:
1. Consider your network and cabling requirements to select an appropriate SFP
transceiver type.
2. Insert the transceiver with the optical connector facing outward and the slot
connector facing down. Note that SFP transceivers are keyed so they can only
be installed in one orientation.
3. Slide the SFP transceiver into the slot until it clicks into place.
Note: SFP transceivers are hot-swappable. The switch does not need to be powered off
before installing or removing a transceiver. However, always first disconnect the
network cable before removing a transceiver.
2 4
2 3
2 4

Figure 3-5. Installing an SFP Transceiver

Installing an SFP Transceiver
L in k
/ A c t
P W R
P o E
D ia g
V 2 H
2 5
2 6
S ta c
k in g
M o d
e
P o E
/ L in k
3
1 2 4 -
2 4 P
3-5