Back Brace
2
• Fit the back brace onto the same frame.
Hint: The back brace will only fit on the frame one way. If it does
not seem to fit, turn it around and try again!
• Insert an M3,5 x 15mm screw into the hole in the frame and tighten.
Seat
1
7
• Fit the seat onto the frame assembly. Push down on the seat to
fit in place.
Frame
Assembly
SIdE VIEW
Assembly
Frame
1
3
• Fit the other frame onto the braces.
• Insert three M3,5 x 15mm screws into the holes in the frame
and tighten.
BOttOM VIEW
1
8
• While holding the seat in place, turn the assembly face down.
• Insert two M4,5 x 18mm washer head screws into the holes in
the back of the seat, as shown.
• Tighten the screws.