Tools Required - Craftsman 917.28925 Operator's Manual

Slope S heet
Keys (I) Oil Drain Tube
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for sh_pping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 1/2" wrench Tire pressure gauge
(2) 7/16" wrenches Utility knife
Phers
When right or left hand is mentioned in this
manual, it means whenyouarein theeperatlng
position (seated behind the steenng wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
Remove all accessible loose parts and
parts cartons from carton.
Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
TO CHECK BATrERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-I 0 amps. (See
"BATTERY" _nMaintenance section of this
manual for charging instructions).
For battery and battery cable installation
see "REPLACING BATTERY" in the
"Service and Adjustments" section in this
manual.
ADJUST SEAT
1. Sit in seat.
2. Lift up adjustment lever (A) and slide
seat until a comfortable position is
reached which allows you to press
clutch/brake pedal all the way down.
3. Release lever to lock seat in position.
NOTE: You may now roll your tractor off
the skid. Follow the appropriate nstructlon
below to remove the tractor from the skid.
_, WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Ensure
tractor is in a well-ventilated area. Ensure
the area in front of tractor Js clear of other
people and objects.
7