Yard Machines 24788345 Operation Manual page 8

SECURE FROM THE UNDERSIDE.
See Figure 8.
1. Place a piece of the cardboard from the carton on a level sudace, Tip the snow thrower forward so that the
housing rests on the cardboard from the box.
2. Thread one 5/16" hex nut all the way onto the eyebolt.
3. Slide the eyebolt onto the chute crank. Insert eyebolt into the hole in the lower handle.
4. Insert the chute crank into the hole provided in the snow thrower cover. Place the end of the crank into the
coupler located inside the snow thrower.
5, Rotate the crank tO align holes, and insert the cotter pin (inside the snow thrower cover). Bend ends of cotter
pin in opposite directions to secure.
6. Secure eyebolt with 5/16" saddle washer and hex nut. The cupped side of washer goes against the handle
Adjust lower hex nut until the eyebolt is positioned so the chute crank turns freely (does not bind).
7. Move upper hex nut down against the lower handle.
8. Tighten lower hex nut securely.
Hex
Chute Crank
/ /
Chute Crank Cotter Pin
Figure 8
ASSEMBLING THE CHUTE
The snow thrower has been shipped with the upper chute pivoted all the way down. Assemble as follows:
Flat
Washer
Hand . _Carriage
Knob___, Bolt
Upper
Chute
No
Gap
/
Figure 9
1. Turn the chute crank until the chute facing straight to the front. See Figure 9.
2. Remove the hand knob, flat washer and carriage bolt from the upper chute.
3. Pivot the upper chute up so there is no gap between the upper and lower chute. Secure with hardware just
removed.