Stopping The Engine - Exmark VANTAGE Operator's Manual

Operation
3. Push in (down) on the PTO switch to the
"disengage" position.
4. Place the throttle midway between the "SLOW"
and "FAST" positions.
5. On a cold engine, push the choke lever forward
into the "ON" position (except Kohler EFI units).
On a warm engine, leave the choke in the "OFF"
position.
6. Turn ignition switch to the "START" position.
Release the switch as soon as the engine starts.
Important: Do Not crank the engine
continuously for more than ten seconds at a
time. If the engine does not start, allow a 60
second cool-down period between starting
attempts. Failure to follow these guidelines
can burn out the starter motor.
7. If the choke is in the "ON" position, gradually
return choke to the "OFF" position as the engine
warms up.
PTO Engagement
DANGER
The rotating blades under the mower deck are
dangerous. Blade contact can cause serious
injury or kill you.
Do Not put hands or feet under the mower or
mower deck when the blades are engaged.
DANGER
An uncovered discharge opening will allow
objects to be thrown in an operator's or
bystander's direction. Also, contact with the
blade could occur. Thrown objects or blade
contact can cause serious injury or death.
Never operate the mower with the discharge
deflector raised, removed, or altered unless there
is a grass collection system or mulch kit in place
and working properly.
The PTO switch engages the cutting blades. Be sure
all persons are clear of mower deck and discharge
area before engaging the PTO.
1. Set throttle to "MIDWAY" position.
2. Release the parking brake.
3. Move the right side motion control lever to the
center, operate position.
4. Continue holding the right side motion control
lever in the center, operate position and pull up
on the blade control switch (PTO) and release.
The clutch should engage and the mower blades
begin rotating.
5. Place the throttle in the "FAST" position to begin
mowing.
Disengaging the PTO
1. Set the throttle midway between the "SLOW"
and "FAST" positions.
2. Push down on the PTO switch to disengage the
blades.
Note: The PTO will be disengaged by releasing
the right side motion control lever and allowing it
to spring outward to the PTO disengage position.
The PTO will not re-engage when the RH motion
control lever is moved out of the PTO disengage
position without pulling up on the PTO switch.
To fully disengage the PTO, continue to push the
switch downward.

Stopping the Engine

1. Bring the unit to a full stop.
2. Move the motion control levers to the neutral
position; move the RH control lever out to the
PTO disengage position.
3. Place the throttle midway between the "SLOW"
and "FAST" positions.
4. Push down on the PTO switch to disengage the
blades.
5. Engage the parking brake.
6. Allow the engine to run for a minimum of 15
seconds, then turn the ignition switch to the
"OFF" position to stop the engine.
7. Remove the key to prevent children or other
unauthorized persons from starting engine.
8. Close the fuel shut-off valve when the machine
will not be in use for a few days, when
transporting, or when the unit is parked inside
a building.
20