Table of Contents
Advertisement
Resetting the
Ethernet Adapter
Restoring the
Ethernet Adapter to
Factory Defaults
Applying Settings
After you set the UART settings, network serial port settings, and
operation mode, select Apply to make the settings take effect.
If the Ethernet Adapter stops responding correctly, you can perform a
reset, which disrupts the network association temporarily, but does not
affect Ethernet Adapter configuration settings that have already been
applied with Apply.
To reset the Ethernet Adapter, under Tools, click Reset Wireless Ethernet
Adapter. In the next page, click Reset.
The Ethernet Adapter can also be reset using the Wireless Infrastructure
Device Manager (Widman). Right-click the Ethernet Adapter in Widman,
and then select Reset.
You can restore Ethernet Adapter settings to the defaults that were set at
the factory either manually or through software.
To restore the settings manually, insert a pointed object (such as the end
of a straightened paper clip) into the reset hole on the back of the
Ethernet Adapter, and hold for five seconds.
Figure 14 Manually Resetting the Ethernet Adapter
RESET
RESET
Using the Configuration Management System
Reset Hole
45
Advertisement
Table of Contents
