Gigabyte GV-R80P256D User Manual page 8

4. Locate the AGP slot. If necessary, remove
the metal cover from this slot; then align your
graphics card with the AGP slot, and press it
in firmly until the card is fully eated.
5. Replace the screw to fasten the card in place,
and replace the computer cover.
6. Plug the display cable into your card; then
turn on the computer and monitor. If your
graphics card came with a DVI connector,
you can connect a flat panel display to the
appropriate connector, as shown below...
To VG A Monitor
To Flat P anel Display
You are now ready to proceed with the installation of the graphics card drivers. Please refer
to next chapter for detailed instructions.
GV-R80P256D(V) Graphics Accelerator
After installation, please connect the power cable to your
GV-R80P256D / GV-R80P256V graphics card, or system
will not boot.
To TV or V CR
- 8 -