To Adjust Cutting Height - Craftsman 917376770 Operator's Manual

TO ADJUST CUTTING HEIGHT
Adjust cutting height to suit your requirements. Medium position isbest for most lawns.
Raise wheels for low cut and lower wheels for high cut.
MODELS WITH "SINGLE POINT" MODELS WITH "QUICK ADJUST'
WHEEL HEIGHT ADJUSTERS WHEEL HEIGHT ADJUSTERS
• All four wheels are adjusted by a single NOTE: For shipping purposes, the rear
lever, wheels on your lawn mower may not be
• Pull adjuster lever toward wheel. To adjusted to the same position as the front
raise mower, move lever forward to wheels. Before operating mower adjust all
desired position. To lower mower, move wheels to the same cutting height.
the lever toward the rear. • Raise wheels for low cut and lower
Lower Wheeladjuster lever
•
wheels
for high cut
wheels for high cut.
Adjust cutting height to suit your
requirements. Medium position is best
for most lawns.
To change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure all wheels are in the
same setting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Lower Wheels for High Cut Plate Tab
Raise
wheels
for low out
Raise Wheels for Low Cut
Lever
10