Installing The Equipment; Introduction; Operating Voltage; Power Cable And Earthing - Ericsson RX8310 User Manual

Installing the Equipment

2 Installing the Equipment
2.1

Introduction

For best performance and reliability follow the instructions for site requirements and
installation in the Reference Guide and only use installation accessories
recommended by the manufacturers.
Do not remove the covers of this equipment. Hazardous voltages are present within
this equipment and may be exposed if the covers are removed. Only Ericsson
trained and approved service engineers are permitted to service this equipment.
2.2

Operating Voltage

This product should be operated only from the type of power source indicated on the
marking label. If you are not sure of the type of power supply to your business,
consult a qualified electrical engineer or your local power company.
Note:
See Table 7 for fuse information and also the Reference Guide for a full power
supply specification.
AC Models
AC models are fitted with a wide-ranging power supply. It is suitable for supply
voltages of 100-240 V AC -10% +6% at 50/60 Hz nominal.
2.3

Power Cable and Earthing

Check that the power cable is suitable for the country in which the receiver is to be
used.
8 (40)
Refer to the Reference Guide for details of the color codes used on the
mains leads.
Warning!
Caution!
EN/LZT 790 0008/1 R1A 2011-03-30