Extension Cords - Craftsman 172.108510 Owner's Manual

EXTENSION CORDS
The use of any extension cord will cause some loss of power.To keep the loss
at a minimum and to prevent overheating, use an extension cord that is heavy
enough to carry the current that the tool will draw.
A wire gauge (AWG) of at least 16 is recommended for an extension cord
100 feet or less in length. When working outdoors ALWAYS use an extension
cord that is suitable for outdoor use.The cord's jacket will be marked WA.
Z_ CAUTION:
Keep extension cords away from the cutting area,
and position the cord so it will not get caught on lumber, tools, etc.
during the cutting operation.
i_k WARNING:
Check extension cords before each use. If damaged, I
replace it immediately. NEVER use a tool with a damaged cord because
I
touching the damaged area could cause electrical shock, resulting in
serious injury.
Extension cords that are suitable for use with your saw are available at
your nearest Sears Store.
ACCESSORIES
The following recommended accessories are currently
available at your local Sears Store.
7 1/4-in. 40-Tooth General-Purpose Cut-Off Blade
7 1/4-in. 35-Tooth Master Combination Blade
7 1/4:in. 200-Tooth Plywood Blade
7 1/4-in. 18-Tooth Carbide Blade
7 1/4-in. 18-Tooth Mach II Silver Series Carbide Blade
7 1/4-in. 24-Tooth Mach II Silver Series Carbide Blade
7 1/4-in. 24-Tooth Combination Carbide Blade
Rip Guide
WARNING:
The use of attachments or accessories that are
not recommended might be dangerous and could resQIt in serious injury.
I
24