Proper Operation - COZY BFT101 Installation And Operation Instructions Manual

PROPER OPERATION
ODS / PILOT FLAME
The pilot pressure has been pre-set at the factory and with proper supply pressure will provide a safe,
reliable ignition source. See Figure 7.
(DRRE(T
FIGURE 7
INCORRECT -
LOW PRESSURE
INCORRECT - OXYGEN
LEVEL DROPPING
BURNER FLAME
All orificing and pressure setting was done at the factory and, with correct supply pressure will provide a safe, efficient
source of heat. If installed above 2,000 ft. elevation, the main burner orifice must be changed. See orifice chart on Page 10
for correct size. If there is any question about the manifold pressure, have a qualified selaTicelnan check using a
manometer. The lnanifold pressure should be 3.0" w.c. t\_rnatural gas and 10.0" w.c. for L.E gas. A proper burner flame
will have a so ft blue outer mantel approxilnately 3.5 in. tall with a darker blue inner mantel approximately 1/4" tall.
1NNER OUTER
MANTEL MANTEL
CORRECT FLAME
FIGURE 8
I
INCORRECT FLAME
Page l2