Royal english oak and winchester oak unvented (vent-free) natural gas log heater 18" and 24" variable manually-controlled and 24" thermostatically-controlled models (33 pages)
Summary of Contents for Comfort Glow Comfort Glow RFN28TC
Page 1
VENT-FREE NATURAL RADIANT FLAM HEATER OWNER'S OPERATION AND INSTALLATION MANUAL RFN28TC 14,000 to 28,000 Btu/Hr with Thermostat "C" Model Shown with Optional Mantel featuring Built-in Base WARNING: Improper installa- tion, adjustment, alteration, not followed exactly, a fire or explosion service, or maintenance result causing property damage,...
VENT-FREE NATURAL GAS RADIANT FLAME HEATER SAFETY 12. Make sure screen is in place before run- This appliance is only for use with the type of gas indicated on the rating plate. ning heater. INFORMATION This appliance is not convertible for use 13.
OWNER'S MANUAL PRODUCT PRODUCT FEATURES IDENTIFICATION Control Knob Ignitor Button Operation This heater is clean burning. It requires no Lighting and outside venting. This heater has been tested and Warning Plates approved to ANS Z21.11.2 standard unvented heaters. State and local codes in some areas prohibit the use of vent-free heaters.
VENT-FREE NATURAL GAS RADIANT FLAME HEATER ASSEMBLY Attaching Brass Front Trim to WARNING: Always have Front Panel burner shield and screen in place ASSEMBLING HEATER Locate brass front trim in brass trim before operating heater. This pre- package. Tools Required: vents excessive temperatures on Slide the head of two truss-head screws heater surfaces.
Page 5
OWNER'S MANUAL ASSEMBLY Top Brass Trim Continued Side Brass Trim Set Screws Assembling and Attaching Brass Trim Adjusting Plate 1. Remove packaging from remaining three pieces of brass trim. Locate four brass screws, two adjust- ing plates with set screws, and two shims in the hardware packet.
Page 6
VENT-FREE NATURAL GAS RADIAN'I FLAME HEATER AIR FOR PROVIDING ADEQUATE Confined and Unconfined Space VENTILATION COMBUSTION The National Fuel Gas Code (ANS Z223. l, 1992 Section 5.3) defines a confined space The following are excerpts from National VENTILATION as a space whose volume is less than 50 Fuel Gas Code.
OWNER'S MANUAL AIR FOR COMBUSTION VENTILATION Continued DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION Determining if You Have a Confined or Unconfined Space Use this worksheet to determine if you have a confined or unconfined space. Space: Includes the room in which you will install heater pl us any adjoining rooms with doorless passageways or ventilation grills between the rooms.
VENT-FREE NATURAL GAS RADIANT FLAME HEATER AIR FOR COMBUSTION VENTILATION Continued Ventilation Grills VENTILATION Into Adjoining Room, Ventilation Option 2 Grills Ventilation Air From Inside into Adjoining Room, Building Option 1 This fresh air would come from an adjoining unconfined space.
OWNER'S MANUAL LOCATING HEATER INSTALLATION CAUTION: If you install the heater in a home garage WARNING: Maintain the mini- NOTICE: This heater is intended • heater pilot and burner must mum clearances shown in Figure for use as supplemental heat. Use be at least 18 inches above 10.
Page 10
VENT-FREE NATURAL GAS RADIANT FLAME HEATER iNSTALLATiON INSTALLATION OPTIONS Marking Screw Locations Tape mounting bracket to wall where Continued There are three options for mounting this heater will be located. Make sure heater. THERMOSTAT SENSING mounting bracket is level. A. Mounting heater to wall BULB B.
Page 11
OWNER'S MANUAL INSTALLATION Tighten both screws until heater Placing Heater On Mounting firmly secured to wall. Do not over Bracket Continued tighten. Locate two horizontal slots on back Attaching To Wall Anchor Method Note: Do not replace front panel at this panel of heater.
Page 12
VENT-FREE NATURAL GAS RADIANT a)FLAME HEATER INSTALLATION Bottom of Heater Securing Hearth Base to Floor Base Position hearth base in desired location. Shipping Continued Screw Mark holes for drilling (See Figure 18). B. MOUNTING HEATER ON Remove hearth base. OPTIONAL HEARTH BASE For carpeted floor, make a small cut with a sharp knife at marked locations before...
Page 13
OWNER'S MANUAL Installation must include a manual shutoff INSTALLATION CONNECTING TO GAS valve, union, and plugged 1/8" NPT tap. SUPPLY Continued Locate NPT tap within reach for test gauge NOTICE: A qualified service per- hook up. NPT tap must be upstream from C.
Page 14
VENT-FREE NATURAL GAS RADIANT FLAME HEATER INSTALLATION Test Pressures Equal To or Less Than Pressure Testing Heater Gas 1/2 PSIG Connections Continued Close manual shutoff valve (see Fig- Open manual shutoff valve (see Fig- CHECKING ure 2l). ure 21). CONNECTIONS Pressurize supply piping system by ei- Open main gas valve located on or near ther using compressed air or opening...
OWNER'S MANUAL OPERATING Keep control knob pressed in for 30 seconds after lighting pilot. After 30 INSTRUCTIONS LIGHTING HEATER seconds, release control knob. • If control knob does not pop up STOP! Read the safety information when released, contact a qualified above.
OWNER'S MANUAL TROUBLESHOOTING _IL CAUTION: Never use a wire, needle, or similar object to clean plug heater and let cool before Note: All troubleshooting items are listed in ODS/pilot. Th is can damage ODS/ servicing. Only a qualified ser- order of operation. pilot unit.
Page 18
VENT-FREE NATURAL GAS RADIAN'I FLAME HEATER TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Burner does not light after ODS/pilot is lit 1. Burner orifice is clogged 1. Clean burner (see Cleaning and Mainte- nance, page 20) or replace burner orifice 2.
Page 19
OWNER'S MANUAL TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
VENT-FREE NATURAL GAS RADIAN'IP FLAME HEATER CLEANING SPECIFICATIONS MAINTENANCE BTU (Variable) 14,000/28,000 Type Gas Natural Only Ignition Piezo WARNING: Turn off heater Pressure Regulator Setting 3" W.C. and let cool before cleaning. Inlet Gas Pressure (in. of water) * Maximum 10.5"...
OWNER'S MANUAL REPLACEMENT PARTS CENTRALS PARTS These Parts Centrals are privately-owned businesses. They have agreed to support our customer's needs by providing original replacement parts and accessories. Note: Use only original replacement parts. This will protect your warranty coverage for Tarantin Tank Co.
OWNER'S MANUAL PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 21 of this manual. RFN28TC PART QTY. NUMBER DESCRIPTION 098304-01 Screw, #10 x 3/8" 100566-01CK Front Panel 100573-01BR Screen Assembly...
Page 24
VENT-FREE NATURAL GAS RADIANT FLAME HEATER ACCESSORIES Purchase these heater accessories from your local dealer. If they can not supply these accessories, either contact your nearest Parts Central (see page 21) or call DESA International's Sales Department at 1-800- _ _H ._ _1111 458-2472 for information.
Page 25
OWNER'S MANUAL ACCESSORIES Continued CORNER MANTEL Unfinished - GMC33U Series Finished - GMC32F Series For use with heater and hearth base. Space- PRESTIGE MANTEL saving comer design featuring clean, classic Unfinished - GMC23U Series lines. Available in a walnut finish or an Finished - GMC22F Series...
WARRANTY INFORMATION KEEP THIS WARRANTY Model Serial No. Date Purchased Always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifications at any ti me without notice. The only warranty applicable is our standard written warranty.