Table of Contents
Advertisement
Getting Started
The Clock
About the Clock
Setting the Clock
Changing
the Clock
The Select Functions
Menu
_!
Change the Beep Volume
•
Always set the clock after installation or after a power failure. Once power
returns to the oven, the clock defaults to 12:00 am.
•
The time of day is displayed in hours and minutes.
•
The clock time will appear during all oven operations except when the timer
is running.
•
The oven is preset to a 12 hour clock and indicates AM and PM To switch
to a 24 hour clock, see "Select Function" section.
•
If you do not complete the operation of setting the clock, the oven will beep
periodically as a reminder to set the clock time. Press OFF to stop the beep-
ing.
1.
CLOCK will be displayed and the hour dig-
its will flash. Turn knob to select hour and
AM or PM.
2.
Press Time. CLOCK will still be displayed
and the minute digits will flash.
3.
Turn knob. Set minutes.
4.
Press Time and the clock is now set.
Note: If operation is not completed, the oven will beep periodically as a reminder
to set clock time. Press OFF.
1.
Press Time. TIMER 1 flashes in display.
2.
Turn knob to select CLOCK.
3.
Press Time and hour digits flash.
4.
Turn knob to change hours.
5.
Press Time again and minute digits flash.
6.
Turn knob to change minutes.
7.
Press Time again and the clock is set.
Note: To cancel the TIME selection when setting the clock, press OFF at any
time while in the clock mode.
SELECT FUNCTIONS is the section of the menu where you can set or change
the range features listed below.
To
1.
access the SELECT FUNCTION menu
Press and hold COOKING MODE press pad for five (5) seconds. SELECT
FUNCTION is displayed.
2.
Turn knob slowly to desired feature. There will be a slight delay before each
message (or feature) can be seen in the display. Turn knob slowly and wait
approximately one second for display to show next feature.
3.
Press START to choose the function.
4.
Turn knob to desired setting and press START.
When all settings for the function are complete, SELECT FUNCTION
flashes again.
5.
Press OFF to exit the Select Functions Menu.
The volume of the control beep can be changed from LOW (softest) to HIGH
(loudest). The control default for beep volume is Medium.
1.
Access SELECT FUNCTIONS Menu.
2.
Turn knob clockwise until VOLUME is displayed.
3.
Press Start.
4.
Turn knob to select volume level Low, Medium or High.
5.
Press Start.
English 14
Hide quick links:
Advertisement
Table of Contents
