What To Do If - Bosch WAS20160UC/18 Operating Instructions Manual

Water isrunning out
No water supply running in
rinsed
The loading door will not
....... open
Cycle does not start
i water is not pumped
out
- Fasten drain hose correctly / replace
- Tighten screw connection of the supply hose
- Start!Pause not selected?
- Water tap not opened?
- Screen possibly clogged? Clean screen -> Page 9
- Supply hose kinked or pinched?
- Safety function active Cycle interrupted? -> Page 4
- No final spin (spin stop = without final spin) selected?
-> Page 4.
- Opening only possible using emergency unlock? -> Page 6
- Start/Pause selected?
- Loading door closed?
- Clean pump -> Page 9
- Clean drain pipe and/or drain hose
- No malfunction - Water is below visible area
Spin results not satisfactory
Spinning several times
Dispenser @ not completely
rinsed out
Odor in washing machine
::;;_ : Foam comes out of the
spenserdr wer
i
::i:W
Strong odor, vibrations and
:::: _:):; ,'walking" during spinning
:Display lamps not functioning
) operation
Cycle runs longer than usual
!;II::_IIZ[Z::!! _
Detergent residueonthe
!:::_::_iiiillaundry.
: ::: :: :} :
Start/Pause blinks very fast
and a signal sounds in Pause
condition
- Wash small and large items together
- Reduced ironing selected? -> Page 5
- Selected speed too slow? -> Page 3
- No malfunction - Imbalance control system equalizes
imbalance
- Remove dispenser Clean detergent dispenser and liquid
detergent insert -> Page 8
- Perform Regular/Cotton Hot cycle without adding laundry
Also use detergent
- Too much detergent added?
Mix 1 tablespoon fabric softener with 1/2 liter water and put
into disperser tl of the dispenser drawer
- Too much soap or non - HE soap used?
Mix 1 tablespoon of fabric conditioner with 1 pt ( 1/2 liter) of
water and pour into detergent dispenser II
- Reduce amount of detergent for next wash cycle
- Are machine feet fixed?
Secure machine feet -> Installation instructions Page 5
- Shipping lock removed?
Remove shipping lock -> Installation instructions Page 3
- Power outage?
- Fuse blown? Flip / replace fuse
- If the malfunction happens repeatedly, call customer service
- No malfunction - imbalance control system equalizes
imbalance by frequent distribution of the wash
- No malfunction - Foam control system is active - a rinse
cycle is turned on
- Some phosphate-free detergents contain water insoluble
residues
- Select Refresh or brush off the laundry after washing
- Water level too high Adding laundry not possible If
necessary close loading door immediately
- Select Start/Pause to continue the cycle
If a malfunction cannot be repaired by yourself or if a repair is necessary:
- Set cycle selector to Off and remove the plug from main power supply
- Close water tap and call customer service -> Page 13