Table of Contents
Advertisement
Appliance details
2.3
Unpacking
the AQ-125-BO
heater
This heater is packed securely.
Before installing the unit, be certain you have the
correct heater for your type of Gas - Propane or
Natural Gas. Identification labels are found on the
shipping box, and on the rating plate which is located on
the right side panel of the cover.
The box includes:
• Pressure relief valve
• Heat shield
•
Mounting
screws
•
Product
registration
card
•
Installation
manual.
Do not lose this manual, there is a charge for a
replacement,
Please complete
and return the enclosed product
registration card.
The AQ125 BO is not approved or designed for:
• Manufactured (mobile) homes, RV's or boats
• Heating or other recirculating/pumping
applications*
• Solar/preheat backup or high temperature booster
use
* This includes domestic hot water circulator pump loop
systems that may previously exist in a home hot water
system. The use of a small electric mini-tank (4-6 gallon
size) should
be used for this application;
when
designed so the pump will circulate the hot water in the
mini-tank only and through the building's hot water
return loop (timed or thermostatic controlled operation
of the pump is commonly done). The AQ125 BO should
be plumbed in line before the mini-tank water heater,
contact BBTNA if further instruction is needed.
2.4
General
rules to follow for safe
operation
•
1. You should
follow
these
instructions
when
you
install
your
heater.
In the
United
States:
The
installation
must conform
with local codes
or, in the
absence
of local codes, the National
Fuel Gas Code
ANSI Z223.1/NFPA
54.
In Canada:
The Installation
should
conform
with
CGA
B149.(1,2)
INSTALLATION
CODES
and /or
local installation
codes.
•
2. Carefully
plan where you install the heater. Proper
clearances
must be followed.
•
3. The appliance
must
be isolated
from
the gas
supply piping system by closing its individual
manual
gas shutoff valve (not supplied
with heater)
during
any pressure testing at pressures
in excess of 1/2Psig
(3.5 kPa).
The appliance
and its gas connection
must be leak
tested before placing the appliance
in operation.
•
4. Keep
water
heater
area clear
and
free
from
combustibles
and flammable
liquids.
Do not locate
the heater over any material which might burn.
•
5. Correct
gas pressure
is critical for the optimum
operation
of this heater. Gas piping must be sized to
provide the required
pressure at the maximum output
of the heater, while all the other gas appliances
are in
operation.
Check with your local gas supplier,
and
see the section on connecting
the gas supply.
•
6. Should overheating
occur or the gas supply fail to
shut off, turn off the gas supply at the manual gas
shut off valve, on the gas line. Note:
manual
gas
shutoff valve is not supplied
with the heater.
•
7. Do not use this appliance
if any part has been
underwater.
Immediately
call
a qualified
service
technician
to inspect
the appliance
and to replace
any part of the control
system and any gas control
which has been underwater.
8 716 473 147
5
Hide quick links:
Advertisement
Table of Contents
