Off Season Storage; Troubleshooting - Bolens 550 Operator's Manual

SECTION 7: OFF-SEASON S TORAGE
Observe the following when preparing the edger for
long-term storage:
• Clean and lubricate unit thoroughly as instructed on
page 10 of this manual.
• Refer to the Engine Manual packed separately with
the edger for engine manufacturers's storage
instructions.
• Coat the edger blade with chassis grease to
prevent rusting and corrosion.
• Store the edger in a dry, clean area. Do not store
next to any corrosive materials, such as lawn
fertilizer.
• Coat the edger, especially any springs and
bearings with a light oil or silicone spray.
IMPORTANT: When storing any type of power
equipment in an poorly ventilated or metal storage
shed, care should be taken to rustproof the equipment.
SECTION 8: TROUBLESHOOTING
Trouble Possible Cause(s)
Engine fails to start Dirty air cleaner
Engine runs erratic
Engine needs to be primed
Fuel tank empty
Stale fuel in gasoline tank
Throttle control lever not in
starting position
Spark plug wire disconnected.
Spark plug fouled
Engine flooded
Spark plug wire loose
Stale fuel in gasoline tank
Vent in gas cap plugged
Water or dirt in fuel system
Dirty air cleaner
Corrective Action
Refer to the Engine Manual packed with your unit.
Push primer bulb two or three times.
Fill tank with clean, fresh gasoline.
Drain gasoline and refill tank with clean, fresh gasoline.
Move throttle lever to FAST position.
Connect the spark plug wire to the spark plug.
Clean, adjust gap or replace spark plug.
Refer to the Engine Manual packed with your unit.
Connect and tighten spark plug wire.
Drain gasoline and refill tank with clean, fresh gasoline.
Clear vent of any debris.
Drain fuel tank. Refill with fresh fuel.
Refer to the Engine Manual packed with your unit.
Refer to the Engine Manual packed with your unit.
Carburetor out of adjustment
Engine overheats Engine oil level low Fill crankcase with proper oil.
Air flow restricted Clean the area around the engine's cooling fins.
Dirty air filter Replace the engine's air filter
Carburetor not adjusted properly Refer to the Engine Manual packed with your unit.
Excessive vibration Edger blade bent or damaged Replace edger blade.
Blade spindle bent or damaged Contact an authorized Troy-Bilt service dealer.
Drive belt slips Belt worn or stretched Replace drive belt.
12