every repaired unit.
Also, tubing and ducts should be routed per Photograph
#1, section 17)
14.
Wheels
•
Remove
six screws from the main housing
•
Remove window, flow indicator cap and belt access door
•
Unsnap main housing from front of base
•
Remove main housing assembly
•
Remove
clip ring on wheel axle
•
Remove
wheel and axle assembly
•
Replace
and reassemble
•
(Note: When reattaching
the main housing,
it is critical that the upholstery
duct tab be properly
located into the slot on top of the motor cover to insure
proper alignment
of main housing over duct. This tab may pop out of the slot
each
time the housing
is removed,
so check
for this condition
on every
repaired
unit.
Also, tubing and duets should be routed per Photograph
#1,
section 17).
15.
Hose
•
Remove
six screws from the main housing
•
Remove
window, flow indicator cap and belt access door
•
Unsnap main housing from front of base
•
Remove main housing assembly
•
Disconnect
hose from air duct
Diseormect
hose solution tube
•
Replace and reassemble
•
Reattach
top cover and secure with six screws (Note: It is eritieai
that the
upholstery
duct tab be properly located into the slot on top of the motor cover
to insure proper alignment
of main housing over duct.
This tab may pop out
of the slot each time the housing
is removed,
so check for this condition
on
every repaired unit.
Also, tubing and ducts should be routed per Photograph
#1, section 17)
16.
Brush Roll
•
Recline handle and place base assembly
upside down on a flat surface
•
Remove
two red pivot arm retainers
Remove
pivot arms and belt
•
Remove
old brush roll
•
Insert new brush roll into cogged belt
Reattach pivot arms and seat brush roll
Reattach
red pivot arm retainers (Note: The guard on the pivot arm must face
down towards the floor)
03/03/99 Rev C