Advertisement
A frozen battery can explode and result in
death or serious injury. DO NOT charge or
jump start a battery containing frozen fluid.
Thaw the battery before putting on a charger
or jump starting.
ALWAYS keep protective structures, guards,
and panels in good repair, in place and
securely fastened. NEVER modify or remove
safety devices.
DO NOT change engine governor settings or
over-speed
engine.
Fumes from engine exhaust can cause injury
or death. DO NOT run engine in an enclosed
area. Always provide good ventilation.
ALWAYS maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
Stop and inspect equipment if you strike an
object or if there is an unusual vibration.
Repair, if necessary, before restarting. Never
make adjustments or repairs with the engine
running.
Mower blades are sharp and can cut you.
Wrap the blade(s) or wear gloves, and use
extra caution when servicing them. NEVER
weld or straighten mower blades.
Rotation of one blade may cause rotation of
the other blades.
Check brake operation frequently. Adjust and
service as required.
Keep all hardware properly tightened.
Stored energy in springs can cause injury.
Maintain or replace safety and instruction
labels, as necessary.
Never store the machine or fuel container
inside a building where there is an open
flame, such as a water heater.
Shut off fuel (if provided) and allow engine to
cool completely
before storing in closed area
or covering unit.
Clean grass and debris from unit, especially
from around muffler and engine, to help
prevent fires.
For extended storage, clean unit thoroughly.
See storage section and Engine Manual for
proper storage.
Use only attachments
or accessories
designed for your unit.
Check attachment
components frequently. If
worn or damaged, replace with
manufacturer's
recommended
parts.
V_,_,.$1 =1 _v_ I :] t'i
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before proceeding.
Tools
Required
Adjustable wrench
Petroleum jelly or dielectric grease.
Unpack
Unit
Remove unit and all other components
from
the shipping container. Engage transmission
bypass lever (see MOVING UNIT
MANUALLYon
page 15). Push unit from
container onto a level surface. Disengage
transmission
bypass lever.
Connect
Battery
See Battery Removal and Installation on
page 20 and perform steps 2 and 3 in the
installation section.
Place
Unit
in Operating
Position
(Figure 3)
NOTE: The seat is shipped with the seat
positioned as far back as possible.
1. Push steering levers aside and tip seat
up.
2. Adjust the seat as needed (see SEAT
ADJUSTMENT
on page 17).
3. Remove hardware from top hole of the
steering lever (Figure 3). Slide steering
lever back to align slot with hole at the
top of the steering pivot arm.
NOTE: Do not tighten hardware before
reviewing ADJUSTING
STEERING LEVERS
on page 22. If no adjustment
is desired
tighten hardware.
4. Adjust steering levers (see ADJUSTING
STEERING LEVERS on page 22).
1
3
2
1. Steering Lever
3. Steering Lever
2. Steering Pivot
Hardware
Arm
Figure 3
Check
Engine
Oil Level
Refer to Engine Manual.
GB-9
Hide quick links:
Advertisement
