Advertisement
grommets with the special screws provided. Note: Don't over-tighten the
screws. Doing so will reduce the vibration and noise-dampening ability of the
rubber grommets.
5.
Slide and lock the tray back into the case.
Repeat the same procedure for the other devices as necessary. Note: If you
6.
choose to install the optional front 92 mm fans to the case, please do it
now. See the instructions under "Cooling System" for more information.
7.
Slide the HDD cage back to the case and fasten the two thumbscrews.
8.
Connect 4-pin molex or SATA power connectors on the power supply to the
power connectors on each of the devices.
5.25" Device Installation
There are four external 5.25" drive bays (one with 5.25" to 3.5" Adapter).
1.
Remove the left side panel of the case.
2.
Remove the plastic cover for the drive bay you want to use.
3.
Slide the drive into the bay from the front of the case.
Fasten the drive using the screws provided in the tool bag. Note: you need
4.
only to fasten the drive through the open side of the drive bay.
5.
Mount the other devices accordingly.
6.
Connect a large 4-pin connector from the power supply to the male 4-pin
connector on each of the devices.
7.
Replace the left side panel of the case.
Chassis Air Guide
The new case includes a chassis air guide, to provide cooling air directly to the
CPU. The air guide consists of three parts: an upper duct, flange, and lower duct.
If you prefer, you can adjust the distance between the lower duct and the CPU, for
maximum cooling efficiency.
You may also install a 80mm intake fan between the air
guide and the case's side panel to further improve the
system's cooling airflow. To install the optional fan:
1.
Remove Chassis Air Guide from the side panel.
2.
Install the optional 80mm fan first by locking it to
the side panel as shown in Picture 3.
3.
Using the fan screws, lock the flange of the air
guide to the fan as shown in Picture 4.
4.
Connect a large 4-pin white connector from the
power supply to the male 4-pin connector on the
fan.
Cooling System
The Rear Exhaust TriCool™ fan:
The NSK 6580B comes with one 120mm TriCool™ fan
preinstalled. This fan has a three-speed switch that lets
you choose between quiet, performance, or maximum
cooling. (See specifications below.) The fan is installed
so that the air is blowing out of the case. Connect a large 4-pin connector from
the power supply to the male 4-pin connector on the fan. Note: The default set-
ting of the fan is Low. We recommend this speed for maximum quiet computing.
5
Picture 3
Picture 4
Advertisement
