Related Manuals for Antec NSK 6580
Summary of Contents for Antec NSK 6580
- Page 1 New Solution Series NSK 6000, 6580 and 6580B User’s Manual Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario...
-
Page 2: The Power Supply
Disclaimer This manual is intended only as a guide for Antec’s Computer Enclosures. For more comprehensive instructions on installing the motherboard and peripherals, please refer to the user’s manuals that come with those components. -
Page 3: Installing The Motherboard
Remove the screws from the right side panel. There are two latches on the side panel. Slide the latches towards the front of the case and swing open the panel. Inside the case you should see the power supply, some wiring with marked connectors (USB, PWR etc.), and installed I/O panel and a power cord. - Page 4 FireWire port to an IEEE 1394 add-on card that comes with an external-type IEEE 1394 connector, you will need a FireWire Internal Adapter. To order one, please visit Antec’s web store at http://www.antec.com/StoreFront.bok and search for part number 30031. This adapter will allow you to connect the front IEEE 1394 port to the external-type connector.
-
Page 5: Device Installation
CONNECTING THE AUDIO PORTS (AC’97 and HDA) There is an Intel standard 10-pin AC’97 connector and an Intel 10-pin HDA (High Definition Audio) connector. You can connect either of them to your motherboard depending on the specification of the motherboard. See instruction below: NOTE: Please check your motherboard manual for your audio header pin layout and make sure it matches the table below. - Page 6 grommets with the special screws provided. Note: Don’t over-tighten the screws. Doing so will reduce the vibration and noise-dampening ability of the rubber grommets. Slide and lock the tray back into the case. Repeat the same procedure for the other devices as necessary. Note: If you choose to install the optional front 92 mm fans to the case, please do it now.
- Page 7 This case comes with two optional 92mm fan mounts in the front of the HDD cage. The front fan should be installed so that the air is blowing into the case from the front. We recommend using Antec TriCool™ 92 mm fans and set the speed to LOW.
- Page 8 Run Cool, Run Reliably, Run with 80 PLUS® Energy Efficient® More than 80% efficient at 20%, 50% & 100% load www.80PLUS.org System Integrators / VAR’s for more information on 80 PLUS® financial and marketing advantages in North America go to www.antec.com/us/80Plus.html ® www.80PLUS.org More than 80% efficient...
- Page 9 1-800-22ANTEC customersupport@antec.com Europe +31 (0) 10 462-2060 europe.techsupport@antec.com www.antec.com © Copyright 2007 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners. Reproduction in whole or in part without written permission is prohibited. Printed in China.