Amana ASD2326HEB Use & Care Manual page 33

Table of Contents

Advertisement

Available languages

Available languages

ice formsin inlet
Water p ressure i sHow.
Water p ressure m ustbebetween 3 5to 100 pounds p er
tubeto ice maker
square inchtofunction properiy,
A minimum pressure o f35pounds p ersquare inchis
recommended
forrefrigerators withwater f iiters,
Saddb vaive notopen compbtdy,
Open saddb vaive compbtdy,
Freezer temperature istoohigh,
See
Temperatore Contro/s pages 8 and 9, Freezer
temperature shouM be between 0° to 2° F (-18° to -17° C}.
Refrigerator
is
Hasdc tubing was used to compbte
The manufacturer recommends using copper tubing for
leaking water
water connection,
installation, Piastb is HessduraMe and can cause
bakage. The manufacturer
is not responsibme for
property damage dae to improper
installation
or
water connection.
Improper water valve was installed,
See Connecting the Water Supply pages 4 and 5, Self-
piercing and _,_"saddle valves cause low water pressure
and may clog the line over time, The manufactarer
is
not responsible
for property damage due to
improper installation or water connection.
Water flow is
Water pressure is low,
Water pressure must be between 35 to 100 pounds per
slower than normal
square inch to function properly. A minimum pressure
of 35 pounds per square inch is recommended for
refrigerators with water filters.
Saddle valve not open completely.
Open saddle valve completely.
Improper water valve was installed.
See Connecting the Water Supp/y pages 4 and 5. Self-
piercing and S_/'saddle valves cause low water pressure
and may clog the line over time, The manufacturer
is
not responsible
for property damage due to
improper installation
or water connection.
Copper tubing has kinks,
Turn off water supply and remove kinks,
If kinks cannot be removed, replace tubing,
Water filter is clogged or needs to be
Change water filter (see page 18},
changed,
Water valve not opened completely,
Open water valve completely and check for leaks,
The minimum flow at dispenser is approximately
10 fluid ounces in nine seconds with a new filter in
place or approximately 10 fluid ounces in five seconds
without a filter.
Dispenser water
Allow approximately 12 hours for water in holding tank
is not cold
to chill.
Refrigerator has been recently installed.
Water supply in holding tank has been
depleted.
Water has settled into water lines
outside holding tank and has warmed to
room temperature.
Air or air bubbles in water.
Discard first glass of water and refill.
Water appears
This is normal when first using the dispenser and wiii
cloudy
disappear with use.
Particles in water
Carbon dust from water filter cartridge.
Initial water ejected through cartridge may contain
and/or ice cubes
harmless carbon dust flushed from cartridge.
Particles are safe for consumption.
Will disappear after the first few uses.
Concentrations of minerals in water will
Particles are not harmful and naturally occur in water
form particles when water becomes
supplies.
frozen and melts.
32

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents