Samsung PCJ534RF Owner's Instructions Manual page 39

S
P E C I A L
2
Press the MODE button and make sure that the CABLE LED is
illuminated.
3
On your Samsung remote control, press SET.
4
Enter 3 digits of the cable box code listed below for your
brand of cable box.
5
Press POWER. Your cable box should turn on. If your cable
box turns on, your remote control is now "set up" correctly.
6
Once your remote control is set up, press the MODE button
any time you want to use the remote to operate your cable
box.
Cable Box
Codes
F
E AT U R E S
The remote control has four
"modes": "TV," "VCR," "CABLE"
and "DVD."
Press the "MODE" button to switch
the remote control to the "Cable"
mode.
Make sure you enter 3 digits of
the code, even if the first digit is a
"0." (If more than one code listed,
try the first one.)
If your cable box does not turn
on, repeat steps 2, 3, and 4, but try
one of the other codes listed for your
particular brand of cable box. (If no
other codes are listed, try each cable
box code, 000 through 077.)
When your remote control is
in the "CABLE" mode, the volume
buttons still control your TV' s vol-
ume. Also, the VCR control buttons
(PLAY, PAUSE, etc.) will still operate
your VCR.
C F : S
HAPTER OUR
4.3
F
PECIAL EATURES