Using The Dishwasher; Lighting Features - GE Monogram ZBD6800 Owner's Manual

Using the dishwasher
Dishwasher
Lighting
Features
(on some
models)
Interior Lights (on some models}
The interior Xenon lights provide better visibility
for loading and unloading. They turn on when the
door is opened and turn off when the door is
latched. The lights will turn off after 15 minutes
if the door remains unlatched. To turn the lights
back on, latch and open the dooE
Do not attempt to replace the bulbs. If light bulb
replacement is necessary, please contact the
GE Answer Center for service bg calling
1.800.626.2000.
End-of-Cgcle Indicator Light (on some models}
The end-of-cgcle indicator light is located on the
right side of the dishwasher, above the handle.
This light comes on when the selected cgcle is
complete. The light will stag on until the door is
opened. The dishes mag be removed at ang time.
Note that the high-efficiencg fan will run quietlg
for BOminutes to 4 hours {depending on the
selected cgcle) after the end-of-cgcle indicator
light is illuminated to continue drging the dishes.
Opening the door and pressing ang kegpad will
stop the fan.
Water
Temperature
The entering water must be at least 120°F (49°C)
and not more than 150°F(66°C),for effective
cleaning and to prevent dish damage.
Check the water temperature with a candg or
meat thermometer. Turn on the hot water faucet
nearest the dishwasher, place the thermometer in
a glass and let the water run continuouslg into the
glass until the temperature stops rising.
Use a
Rinse
Agent
A rinse agent improves drg performance,
reduces spots and prevents new film buildup
on gour dishes, glasses, flatware, cookware
and plastic. Jet-Drg ® and Cascade Crgstal
Clear ® are recommended rinse agents for
Monogram Dishwashers.
The rinse agent dispenser holds 3.5 oz. of rinse
agent. Under normal conditions, this will last
approximatelg one month. Trg to keep it full,
but do not overfill.
To fill the rinse agent dispenser, make sure the
dishwasher door is fullg open.
Indicator
window
Rotate the dispenser cap counterclockwise and
lift it out. Add rinse agent until the indicator
window shows full.
Clean up ang spilled rinse agent with a damp
cloth. Replace the dispenser cap.
The amount of rinse agent released into the final
wash can be adjusted. The factorg setting is at
the midpoint. If there are rings of calcium (hard
water) spots on dishes, trg a higher setting. If
there is foaming, use a lower setting.
To adjust the setting, remove the dispenser cap;
then turn the adjuster counterclockwise to
increase the amount of rinse agent or clockwise
to decrease the amount of rinse agent dispensed.
Rinse agent
adjuster